||Units have fully shrouded
weight stacks in full compliance with ASTM and EN standards.
Each selector plate is entirely precision-machined on all surfaces. Top plate has replaceable precision self-lubricating bushings. The plates feature a black painted protective finish.
Guide rods are precision centerless ground, polished, with corrosion-resistant plating for smooth operation and rust retardation.
The weight stack is elevated to facilitate user pin selection from seated position.
||Premium-quality 3D urethane moulded-foam padding for maximum comfort. Fabric meets or exceeds California fire regulations (Bulletin 117, section E).
Automotive-grade, two-textured fabric features double topstitching on all seams.
||Easy to understand exercise placards feature large set-up and start and finish position diagrams that are visibly easy to identify.
|Water Bottle and Accessories Holder
||The drink and accessory holder features a large open, even surfaced area which is easily accessible and easy to keep clean.
|Bearings and Pivot Points
||Oversized, linear, re-circulating ball bearings run on case-hardened shafts, and are sealed and self aligning.
Pivot points and joints feature motor-grade sealed ball bearings, or sleeve bearings, utilising either oil-impregnated bronze bushings or pre-lubricated nylon bushings.
Bolts are grade 5 or above in all applications.
||Ratcheting seat adjustments require only a lift to release the lever.
Handles include slip-resistant rubber sleeves with machined alloy end-caps.
Adjustment points are highlighted with a contrasting colour for ease of use.
|Pulleys and Cables
||Glass-fibre reinforced nylon pulleys for durability, with precision motor grade ball bearing pulleys.
All cables consist of 7 x 19-strand aircraft cable coated with black pressure-extruded nylon (either 3/16-inch cable coated to 1/4 inch or 1/8-inch cable coated to 3/16 inch). The cables conform to specification MIL-W-83420D-BARE cable only.
When used, redirection pulleys route cables close to frame to minimise chance of external interference.
|Frame and Finish
||The frame is 11 gauge (0.3 cm; 0.120 in) 2x10 cm (2x4 in) electroweld steel racetrack tubing.
Movement arms are made of electroweld steel round tubing.
The abrasive grit pre-finish is followed by an electrostatically applied, heat-cured powder coat.
||Angled pad positions arms for maximum comfort and efficiency.
Ratcheting gas-assisted seat adjusts to fit a wide range of users.
Weight stack 73 kg (160 lbs).