| Upholstery |
Premium-quality 3D urethane molded-foam padding for maximum comfort. Fabric meets or exceeds California fire regulations (Bulletin 117, section E). Automotive-grade, two-textured fabric features double top stitching on all seams. |
| Weight Stack |
Units have fully shrouded weight stacks in full compliance with ASTM and EN standards. Each selector plate is entirely precision-machined on all surfaces. Top plate has replaceable precision self-lubricating bushings. The plates feature a black painted protective finish. Guide rods are precision centerless ground, polished, with corrosion-resistant plating for smooth operation and rust retardation. The weight stack is elevated to facilitate user pin selection from seated position. |
| Rubber Feet |
Yes |
| Accessory Holder(s) |
Yes |
| Integrated Add-on Weight |
Yes |
| Instructional placard |
Step-by-step machine identifier and instructional placards are positioned on the inside of the weight stack for easy reading by user. |
| Water Bottle and Accessories Holder |
The drink-and-accessory holder features machine-identifier graphics on both sides for easy identification and optional circuit numbering. |
| Adjustments |
Ratcheting seat adjustments require only a lift to release the lever. Handles include slip-resistant rubber sleeves with machined alloy end-caps. Adjustment points are highlighted with a contrasting color for ease-of-use. |
| Bearings and Pivot Points |
Oversized, linear, re-circulating ball bearings run on case-hardened shafts and are sealed and self aligning. Pivot points and joints feature motor-grade sealed ball bearings, or sleeve bearings, utilizing either oil-impregnated bronze bushings or pre-lubricated nylon bushings. Bolts are grade 5 or above in all applications. |
| Pulleys and Cables |
Glass-fiber-reinforced nylon pulleys for durability, with precision motor-grade ball bearing pulleys. Cable consists of 3/16 inch (7""x19"") aircraft cable coated with black pressure-extruded nylon to 1/4 inch or 1/8 inch and coated to 3/16 inch. The cables conform to specification MIL-W-83420D-BARE cable only. When used, redirection pulleys route cables close to frame to minimize chance of external interference. |
| Frame and Finish |
The frame is 11 gauge (.120 in) 2x4"" electroweld steel racetrack tubing. Movement arms are made of electroweld steel round tubing. The abrasive grit pre-finish is followed by an electrostatically applied, heat-cured powder coat. |
| General Features |
Knee pad moves with user's lower legs; no thigh hold-down pad required. Start position and roller pads adjust for optimal exercise mechanics. Weight Stack 260 lbs (119 kg). |
